Due to the lack of 4G Support for Quad core processors,Samsung in the USA released variants which possesses dual core processors with improved clock speed and RAM.Now in this case we are speaking of the Samsung Galaxy S3 SPH-L710 from the US network carrier Sprint.It has 1.5Ghz processor dual core processor with 2GB RAM.Quite good we must say.Now if you are one of the proud owners of this Sprint Galaxy S3 and want to Root your phone, then no worries.We have provided a step by step tutorial to easily Root Sprint Galaxy S3 SPH-L710 with no problems whatsoever.
Now, without waiting any further, lets commence the process to Root Sprint Galaxy S3 SPH-L710
Reasons to Root Sprint Galaxy S3 SPH-L710 :
Basically if you intend to get access to special system files , if you want to edit those files or customize you need to Root Sprint Galaxy S3 SPH-L710 .In simple words ,Rooting provides you and the apps to get a control of your entire mobile system.You basically become a “Superuser” through which you can alter :
1. Preinstalled system apps like clocks ,maps etc.
2. Boot screen images
3. Special Apps
4. Edit themes
5. To make a backup of all the applications installed.
Methods provided here are often considered risky, can brick the device and void warranty.So , it is advised to read the below mentioned procedures with utmost attention and meticulously.This is solely at your own risk, we are not to be held responsible for any damaged done to the device !
Lets have a look at the essential Pre Requistes:
1.Minimum 60% of your phone battery must be charged.
2.Back up your phone data.
3.Make sure that you have installed Samung drivers on your computer.
4.Sync your contacts with gmail.
5.Enable USB debugging mode(Settings –> Applications –> Development –> USB Debugging)
Following is the Detailed Method to Root Sprint Galaxy S3 SPH-L710 :
Now,to begin with the process to Root Sprint Galaxy S3 SPH-L710 , initially you need to download Odin software. Following is the ODIN download link. Odin Root Sprint Galaxy S3 SPH-L710
Next, we need to download the clockworkmod.tar to Root Sprint Galaxy S3 SPH-L710 Firmware . Following is the File to Root Sprint Galaxy S3 SPH-L710. Download it from the attached files in that thread.
Also we need to download Superuser.Following is the download link for it–> Superuser Sprint Galaxy S3. Download it from the attached files in that thread.After downloading transfer that superuser zip file into the sdcard.
Now you need to switch of your device Galaxy S3 SPH-L710 and then your device need to boot in the download mode. In order to do the same ,
do press the Volume down Key and OK button simultaneously and then press the Power Button too.Now, when you get the Warning message just press the Volume Down Key to enter the download mode.
Now with the Galaxy S III being in download mode, plug in your phone into the PC via USB cable and then open the ODIN tool (Downloaded from step 1).
Once the phone is connected , ID:COM section in the top left corner would become yellow thereby indicating that connection has been established with the device succesfully.
Now make sure that you tick on F.Reset Time and Auto Reboot Checkboxes
Now in the PDA tab in odin , upload the “clockworkmod.tar” file you had downloaded (from step 2).
Now everything required has been set.You can check the image below.Off course you need to upload that .tar file in PDA section!!
Now in order to start the process to Root Sprint Galaxy S3 SPH-L710 , click on the start tab and in no time, it will install ClockWorkMod CWM Recovery in your Sprint Galaxy S3. While this process is on your device may reboot several times but no need to worry about it.
Then when the final reboot takes place, “Pass” would be displayed on top left corner in ODIN and also the phone will automatically reboot and then you can disconnect your Samsung Galaxy S3 SPH-L710 from Computer.
Now Reboot your phone in the Clock Work Mod CWM mode by pressing Volume Up+Home+Power Button simultaneously and then your Sprint Galaxy S3 SPH-L710 will boot in CWM reovery.
Now go to “install zip from sdcard” and then “chose zip from sdcard” and select the superuser zip file that you had transferred in your sdcard.And then click yes to install it.And thus after installing it Go back and select “Reboot System Now”.Thus doing so Sprint Galaxy S3 would reboot and thus your Sprint Galaxy S III will become rooted.The image below is the app and will be seen in the app menu.
Having done that, head over to the Google Play and search for Busybox and download it and then install.Run it and follow the easy instructions to get it set up.
Now run the Superuser and do the following ->> Settings>>Su binary>>Update and do the binaries update.
See, how an easy task it was to Root Sprint Galaxy S3 SPH-L710 !!!No sarcasm intended !!